I continued on with the install of the LokSound - Select Direct decoder into the Proto 2000 RDG - GP7. I had to cut out and Dremel several sections of the weight so that i could install the decoder.
You can see the section that have been taken out using the Dremel tool by the shiny surface.
The Select Direct - Decoder required clearance underneath the solder tabs so that they wouldn't short out on the frame.
The speaker was going to be mounted just in front of the decoder and right behind the cab but there wasn't enough room so it will mounted underneath the cab roof.
You can see the sections cut out underneath the solder tabs on the decoder.
The decoder wired and installed, it was at this stage when I went to program the decoder that I realised it was faulty and the sound amplifier isn't working...
Jas...
No comments:
Post a Comment